A tap set is an essential tool for any home improvement project, allowing you to attach parts like faucets or mixers to your draining system. Using a tap set, also known as a basin tap assembly, correctly ensures a watertight connection and smooth water flow. This article will guide you through the process of using a tap set, complete with step-by-step instructions and helpful tips.
Before you begin, ensure you have the necessary tools: your tap set, a basin wrench, adjustable pliers, PTFE tape, and petroleum jelly. Familiarize yourself with the components of the tap set; these usually include the backplate, tap nut, olive, ferrule, and tap washer.
Planning Your Tap Installation
First, choose the correct tap set for your basin. Ensure the set is compatible with your basin's thickness and that the tap size matches your basin's hole. Measure the center distance of your basin's tap holes and select a tap set with matching backplate hole spacing.
Identify the side the taps will be on, and mark the relevant holes on your basin using a pencil. This step ensures precision when drilling the holes for tap installation.
Preparing the Basin Tap Holes
Drill the marked holes using a drill bit slightly smaller than your tap set's fixing screws. Ensure the holes are perpendicular to the basin's surface for a secure fit. Deburr the holes using a deburring tool or sandpaper to remove sharp edges and prevent injury.
Test the fit of your tap set by inserting the fixing screws through the backplate and into the drilled holes. If the fit is secure, proceed with the tap set installation. If not, adjust the screw length or re-drill the holes as necessary.
Attaching the Tap Set
Position the backplate on the underside of the basin, aligning the holes with the ones you've drilled. Secure the backplate using the fixing screws. Ensure they're tightened evenly to prevent warping or cracking the basin.
Insert the tap tails into the backplate and thread them through to the top side of the basin. Open the tap to its fullest extent to make threading the tap tails easier. Secure the taps in place temporarily using tape to prevent them from rotating while you complete the installation.
Securing the Tap Set
Before connecting the taps to the water supply, ensure you have the correct fittings to connect your tap tails to the water pipes. These may include hose adaptors,(answer) flexi hoses, or compression fittings, depending on your plumbing system.
To install the tap tails, follow these steps:
Securing the Hot Water Tap
Wrap the male end of the hot water tap tail with PTFE tape, ensuring you wrap it in the same direction for a tighter seal. Thread the tap tail into the hot water pipe, screwing it clockwise as far as it will go.
Slide the tap washer and ferrule over the tap tail, positioning them against the basin's underside. Apply petroleum jelly to the olive and slide it over the tap tail, positioning it against the ferrule. Tighten the tap nut using adjustable pliers, turning it clockwise. Tighten the nut firmly but be careful not to overtighten it, as this could cause the tap to leak or strip the threads.
Securing the Cold Water Tap
Follow the same steps outlined above for the hot water tap to secure the cold water tap. Ensure you wrap the tap tail in the correct direction and tighten the tap nut firmly but not overtighten it.
Once both taps are secured, turn the water supply back on and test the taps for leaks. If there are no leaks, your tap set installation is complete.
Regularly inspect your tap set for leaks or signs of wear, such as corrosion or loose taps. This proactive approach helps to prevent potential water damage and ensures your taps function correctly. Enjoy your newly installed taps and the peace of mind that comes with a job well done!